Kit for motorcycles

1. EX120 FOR MOTO EQUIPMENT - engine renewal.

Gel revitalizant intended for restorative repair and wear protection of the parts of engines up to 1000 cm3 in displacement (with a separate or common lubrication system).

• Used for mopeds, motorcycles, water and utility equipment (lawn mowers, petrol saws, rotary hammers, drills, etc.).
• The gel revitalizant provides a triple effect – repair, protection and economy.
• Thanks to a 20% higher concentration of the active substance, better protection against wear and a greater restorative effect are ensured.

Use with a common fuel and lubrication system:

1. Dissolve the contents of the syringe in 20-30 ml of oil. The oil temperature must be no lower than 35°C. Before filling with fuel, pour the mixture into the tank.
2. Fill the tank with fuel.
3. Let it run at idle for 2-3 minutes.
4. Operate in the normal mode.

Use with a separate lubrication system:

1. Dissolve the contents of the syringe in 20-30 ml of oil. The oil temperature must be no lower than 35°C.
2. Warm the engine up to operating temperature.
3. Pour the mixture into the engine.
4. Let it run at idle for 2-3 minutes.

2. Lubricant for lubricating motorcycle chains.

It is used for lubricating the chains of motor vehicles and bicycles and protecting them against chain wear. Specially developed for high-speed and heavily loaded motorcycle chains. Contains no mechanical impurities or water.

• Adheres well and stays on the chain at high rotation speed.
• It has a high penetrating ability and reliably lubricates all roller surfaces.
• Protects the chain against stretching.
• Protects against corrosion.

USE:

• Remove dirt and the remains of old lubricant.
• Shake the aerosol can.
• Spray the lubricant onto the inner side of the chain along its whole length and leave to dry for 5-10 minutes.
• Use every 300-500 km of mileage and every time water has got onto the chain.