Skip to content
CUSTOMER SUPPORT: +370 685 777 56
XADO RED ANTICARBON - Image 1
XADOCar chemistry

XADO RED ANTICARBON

Article no. XA 41011
32 €
Prices incl. VAT
In stock — Šakiai

Order by 16:00 — Omniva ships today

1
Not sure it fits your car? Ask our mechanics
Same-day dispatch — order by 16:00
24-month guarantee
14-day returns
In stock in Šakiai

Product information

All-round decoking agent.

A new formula of a fast-acting product designed to soften and remove stubborn carbon deposits from the piston crowns and rings of petrol and diesel engines. Removes all carbon deposits and resin contamination from the cavities of the cylinder-piston group.

Frees up the rings.

Cleans cylinders and pistons, combustion chambers and valves of all kinds of contamination (carbon deposits, coke, varnish, resins).
Evens out compression in the cylinders.
Removes deposits from spark/glow plugs.
Safe to use with catalytic converters, oxygen sensors, rubber products and seals.

Use:

  • Warm up the engine. The engine must be warm, but not hot.
  • Unscrew the spark plugs (injectors or glow plugs).
  • Disconnect the connector of the ignition distributor sensor, the Hall sensor or the commutator. Disconnect the fuel supply to the cylinders.
  • Spray the product into each cylinder in turn (up to 5 s) through the hose nozzle. Put the spark plugs (injectors or glow plugs) back in, thus ensuring that the product does not evaporate. Wait 10–20 minutes.
  • Unscrew the spark plugs (injectors). Cover the spark plug holes with an absorbent cloth so that dirt flying out does not land on the paint of the car body parts. Crank the engine with the starter for a few seconds. The procedure can be repeated 2–4 times.
  • To avoid "dry" friction when starting the engine after the carbon deposits have been removed, it is recommended to pour 10–15 mg of fresh engine oil into each cylinder.
  • Install the spark plugs (injectors or glow plugs), connect the wires and sensors and reconnect the fuel supply.
  • Start the engine and let it run at higher revs for up to 15 minutes. During this time the softened coke residues will be removed through the exhaust system*.

Notes:
* To remove the remaining contaminants completely, it is recommended to drive 5–10 km at the maximum permitted speed.

Dosage:

  One 320 ml aerosol can is enough to remove carbon deposits from 20 cylinders.

Pack:

Aerosol can 320ml XA 41011

VIEW ALL