SENKE rear wheel hub

SENKE rear wheel hub: the diagram marks 135 mm across the disc, 82 mm in height, 55 mm between two hole centres and a 15 mm central bore. Before ordering, measure your old hub.

• The hub is the centre of the wheel: the axle runs through it, and a bearing is fitted at its centre, covered by a black oil seal
• We measured the ends of the lines: 135 mm – the disc diameter from edge to edge, 55 mm – between the centres of two neighbouring holes, 82 mm – the height from the top ring to the projection below the bottom of the disc
• At the centre, the lines rest on the outer edge of the black oil seal (47 mm), on its inner bore (27 mm) and on the edges of the central bore (15 mm)
• On the flange – four holes and four elongated slots between them; the hub is light, silver-coloured
• In the second photo, from the other side, you can see four radial ribs, the cast marking YSSG and a round mark with the number 14
• The photo gives neither the bearing number nor fitment for a specific SENKE model

To be straight with you: which SENKE model and which years the hub fits is not written in the name, and we do not know what the marking YSSG means. Before ordering, measure your old hub's disc diameter, the distance between the holes and the axle thickness, and send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56