DELTA rear hub with sprocket 428 41z

DELTA rear hub with sprocket 428, 41 teeth: 428-41T is stamped on the sprocket, the drawing marks 170 mm across the teeth, 113,8 mm across the hub body and a 16,9 mm centre hole. Compare it with your old hub and sprocket.

• This is the rear wheel hub together with the chain sprocket: the sprocket is bolted on with four bolts, with light-coloured plates under their heads
• The drawing's lines rest as follows: 170 mm – across the tips of the sprocket teeth, 113,8 mm – the diameter of the hub body, 46,8 mm – the diameter of the round ring around the bearing, 16,9 mm – the diameter of the centre hole
• In the side photo, 60 mm is measured from the top of the body's lugs to the bottom of the sprocket
• 428-41T and WY are stamped on the sprocket, the drawing marks 41 T by the teeth, and the name has 428 and 41z: all three sources match
• In the centre – a bearing with a black oil seal; on the other side – four rectangular lugs and four round sockets with holes. The sprocket is black, with four large cut-outs, the body is light grey
• The photo gives neither the bearing number nor the bolt size

To be straight with you: which DELTA model and which years this hub is for is not specified in the name. Before ordering, count the teeth on your old sprocket, measure the axle thickness and the hub body diameter, and send us a photo of the old part – we will check it before you order.

24-month warranty · tel. +370 685 777 56