Hydraulic brake pipe (hose) 1020mm

Hydraulic brake hose, marked 1020 mm in the name. This card has no photo of its own – both photos are shared with the product "Hydraulic brake pipe (hose) 900mm", so we describe the appearance as for the whole line: the sleeve is braided from steel wire, and at the ends are swivel eyes (banjo) on crimped fittings.

• How we measure the length: in the photo the arrows rest on the ends of the crimped fittings, not on the edges of the eyes. With the eyes the product is longer, so measure your old hose the same way – from fitting to fitting
• The only product in this category where the diameters can be read is the 1200 mm hose with a black rubber sleeve: it has "Ø7.5mm × Ø3.2mm" printed on it – outer 7,5 mm, inner 3,2 mm. Whether the same numbers apply to this product, the maker did not state
• In the photo of the 400 mm hose, both fittings are marked with a red callout "D 10" – that is the eye's bore that the bolt goes into. For this product the maker did not write that number
• Printed on the braided sleeve is "DOT SAE" – that is a marking, not a specific brake fluid class; check your master cylinder cap for which fluid to use
• Both photos on this card match byte-for-byte with the product "Hydraulic brake pipe (hose) 900mm" – this product has no photo of its own, so we do not describe the appearance from it
• In the supplier data for this card, "total length: 925mm" was entered – that is 95 mm LESS than the 1020 mm stated in the name, and the fittings would not add that much. The same 925 mm is entered for the 900 mm product too, where it fits
• The supplier code given for this product and for the product "…2200mm" is the same, even though the lengths differ by more than double. So we do not give the code as an ordering key – rely on the name
• Each fitting needs a bolt and two sealing washers – they are in this same category. The bolts differ by thread pitch: M10x1,00 and M10x1,25. Each pitch comes both plain and with a bleed point. Choose the plain one if your caliper has its own bleed point
• The hose is replaced not by a wear number, but when it bulges under lever pressure, when fluid weeps past the fitting, or when the lever stays soft even after bleeding
• The other end of the hose goes to the caliper; the caliper itself is a separate product, listed as "Disc brake cylinder (caliper)"
• After changing the hose, the system needs to be bled of air and topped up with fluid – the kind your master cylinder cap specifies; brake fluid is sold separately, in the category "Oils & care"
• This category holds two kinds of product: the hoses themselves, and their connecting parts – a splitter, bolts and washers. This is not one kit, but separate products

To be straight with you: the name says 1020 mm, the supplier data says 925 mm, and the photo is shared with the 900 mm product. We are asking the maker. Which specific machine and which years this product is for, the maker did not state, and we do not guess – but we can compare dimensions for you: write us your model and year. Before ordering, straighten out your old hose and measure it from fitting to fitting, and compare the fittings with the photo – or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56