Hydraulic brake bolt M10x1,00 with bleed point

Hydraulic brake bolt M10x1,00 with bleed point – an eye bolt with a separate bleed nipple screwed into its head. The thread is marked in the name: M10 with a 1,00 mm pitch.

• The photo shows a zinc-plated bolt with a cross-bore, a hexagon head, a lock nut and a screwed-in bleed nipple
• A bleed point is needed where the caliper itself has no bleed point: you let the air out through the eye bolt itself
• This photo is SHARED by four products in this category, and this card has no photo of its own. So we describe only what the photo shows, and which of the four products was photographed – the maker did not mark
• The thread pitch is the number that decides: M10x1,00 and M10x1,25 differ by a quarter of a millimetre, and one does not fit in place of the other. Unscrew your old bolt and compare
• The same bolt with a 1,25 mm pitch is a separate product – "Hydraulic brake bolt M10x1,25 with bleed point"
• In the supplier’s data this product and the washer "with a gasket" carry the same code, though they are different parts. We do not give the code as an order key
• The bolt needs two sealing washers – they are in this same category
• After changing the hose, the system needs bleeding and topping up with fluid – whatever your master cylinder cap specifies; brake fluid is sold separately, in the "Oils & care" category
• This category holds two kinds of products: the hoses themselves and their connecting parts – the tee fitting, the bolts and the washer. This is not one kit but separate products

To be straight with you: the photo is shared by four products, and the maker did not state the bolt’s length. Which exact machine and which years this product is for, the maker did not state, and we do not guess – but we can compare dimensions: write us your model and year. Before ordering, unscrew your old bolt and measure the thread diameter and pitch – or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56