Hydraulic brake pipe (hose) 2200mm

Hydraulic brake hose, marked in the name as 2200 mm. The sleeve is braided from steel wire, with swivel eyes on crimped fittings at the ends.

• In the supplier data, three listings for this product had "total length: 925mm" recorded – more than twice as short as the 2200 mm stated in the name. That same 925 mm is also recorded on two other cards of this line, so we take it as copied over rather than measured
• The supplier code given for this product and for the "…1020mm" product is the same. We do not give the code as an order key – go by the name
• The neighbouring card closest in length in the list is marked 2100 mm, and its photo has the caption "210 cm"; this product's photo has no caption
• How we measure length: in the photo the arrows rest on the ends of the crimped fittings, not on the edges of the eyes. With the eyes included the product is longer, so measure your old hose the same way – from fitting to fitting
• The only product in this category whose diameters can be read is the 1200 mm hose with a black rubber sleeve: it has "Ø7.5mm × Ø3.2mm" printed on it – 7.5 mm outer, 3.2 mm inner. Whether the same numbers apply to this product, the maker did not mark
• In the photo of the 400 mm hose, both fittings are marked with a red caption "D 10" – this is the eye bore that the bolt goes through. The maker did not write this number for this product
• Each fitting needs a bolt and two sealing washers – they are in this same category. Bolts differ by thread pitch: M10x1,00 and M10x1,25. For each pitch there is both a plain bolt and the same one with a bleed point. Choose the plain one if your calliper already has its own bleed point
• The hose is replaced not by a wear number, but when it bulges as you press the lever, when fluid seeps from the fitting, or when the lever stays soft even after bleeding
• The other end of the hose goes to the calliper; the calliper itself is a separate product, listed as "Disc brake cylinder (calliper)"
• After fitting the hose the system needs to be bled and topped up with fluid – the type stated on your master cylinder cap; brake fluid is sold separately, in the category "Oils & care"
• This category holds two kinds of products: the hoses themselves and their connecting parts – the splitter, bolts and washers. These are not one set, but separate products

To be straight with you: the name says 2200 mm, the supplier data says 925 mm, and the photo has no length marked. We are asking the maker. Which specific machine and which years this product fits, the maker did not state, and we do not guess – but we can compare the dimensions for you: write us your model and year. Before ordering, straighten out your old hose and measure it from fitting to fitting, and compare the ends with the photo – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56