Hydraulic brake pipe (hose) 900mm

Hydraulic brake hose, marked 900 mm in the name. This listing has no photo of its own – both photos are shared with the item “Hydraulic brake pipe (hose) 1020mm”, so we describe the look as for the whole line: the sleeve is braided from steel wire, and at the ends – swivel eyes (banjo) on crimp ferrules.

• How we measure the length: in the photo the arrows rest on the ends of the crimp ferrules, not on the edges of the eyes. With the eyes the item is longer, so measure your old hose the same way – from ferrule to ferrule
• The only item in this category with readable diameters is the 1200 mm hose with a black rubber sleeve: it has “Ø7.5mm × Ø3.2mm” printed on it – outer 7,5 mm, inner 3,2 mm. Whether the same numbers apply to this item, the maker did not mark
• On the 400 mm hose’s photo, both end fittings are marked with a red callout “D 10” – this is the eye’s bore that the bolt goes through. The maker did not write that number for this item
• Printed on the braided sleeve is “DOT SAE” – this is a marking, not a specific brake fluid class; check your master cylinder cap for which fluid to use
• Both photos of this listing match the item “Hydraulic brake pipe (hose) 1020mm” byte for byte. Neither of the two has a photo of its own, so we do not describe the look from them
• In the supplier’s data, the SAME length was recorded for both listings – 925 mm. For this item it differs from the name by 25 mm, which is what the end fittings add up to; for the neighbouring item it differs by 95 mm, and there it does not fit
• Each end fitting needs a bolt and two sealing washers – they are in this same category. The bolts differ by thread pitch: M10x1,00 and M10x1,25. Each pitch comes both as a plain bolt and as the same bolt with a bleed nipple. Choose the plain one if your caliper already has its own bleed nipple
• The hose is replaced not by a wear number, but when it bulges under lever pressure, when fluid seeps out through the ferrule, or when the lever stays soft even after bleeding
• The other end of the hose goes to the caliper; the caliper itself is a separate item, listed as “Disc brake cylinder (caliper)”
• After fitting the hose, the system needs bleeding of air and topping up with fluid – the type your master cylinder cap specifies; brake fluid is sold separately, in the “Oils & care” category
• This category holds two kinds of items: the hoses themselves and their connecting parts – the three-way fitting, bolts and washer. These are not one kit, but separate items
• Supplier code WI ZQ4136 – quote it again when ordering

To be straight with you: the photo is shared between this item and the 1020 mm one, and the supplier recorded the same length for both – 925 mm. For which specific machine and which year this item is meant, the maker did not state, and we do not guess – but we can compare dimensions: write us your model and year. Before ordering, straighten out your old hose and measure it from ferrule to ferrule, and compare the end fittings with the photo – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56