Rear hub DELTA

Rear DELTA hub: the drawing marks 114 mm across the disc, 58 mm and 44 mm in height, a Ø 54 mm ring around the bearing, Ø 26 mm at the oil seal and 50 mm at the holes. Check it against your old hub.

• The first photo shows, together with the hub, four studs threaded at both ends, four nuts and two bent locking plates with two holes each; whether they are all included in the set is not stated on the card
• We checked the ends of the lines: 114 mm is the disc diameter, 58 mm is the height from the top of the lugs to the bottom of the collar, 44 mm is from the disc surface to the bottom of the collar
• The Ø 54 mm arrows rest on the edges of the round ring around the bearing, the Ø 26 mm ones on the inner edge of the black oil seal, and the 50 mm is marked between lines drawn through the centres of two adjacent holes
• The hub is not the same in every photo: in two of them a bearing with a black oil seal is fitted in the centre, while in three others the bearing seat is empty. Whether the bearing is included in the set cannot be seen from the card — ask us before ordering
• On one side — four rectangular lugs and four threaded holes, on the other — a collar with four lugs
• The photo gives neither the bearing number nor fitment to a specific DELTA model

To be straight with you: the label next to one arrow at the bearing is blank in the drawing, so we do not write its figure. The name states only DELTA — without a model or a year. Before ordering, measure your old hub's disc diameter and the distance between the holes, send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56