Maximum for Diesel Truck

• Restores the surfaces of parts and compensates for ongoing wear.
• Evens out and increases compression in the cylinders.
• Raises the pressure in the lubrication system to the nominal level.
• Creates an effective system for protecting parts against loads and overheating.
• Improves the lubricating properties of the oil and the tribological characteristics of engine units.
• Increases engine power and dynamics.
• Reduces the noise and vibration level.
• Increases the engine's service life.
• Guarantees engine protection against wear for 100 000 km of mileage

Use

Before use, the temperature of the contents must be no lower than +25 °C. Shake the bottle. Pour its contents into the oil filler port of an engine warmed up to operating temperature. Start the engine and leave it running at idle for 3-5 minutes.

Dosage

1 bottle (950 ml) for engines whose lubrication system volume is 30-45l. 

Notes

• specially designed and tested for heavy-duty vehicles with turbocharged diesel engines;
• compatible with all oil types;
• the revitalization process takes place over 1-1,5 thousand km of mileage; it is not recommended to change the oil during this period;
• it is recommended to use XADO Maximum for Diesel Truck again after 100 000 km of mileage;
• to ensure the highest level of engine wear protection, it is recommended to use XADO Atomic Oil engine oils afterwards;
• RF=100 means that when the product is used, the engine goes through the entire revitalization cycle, is fully restored and is guaranteed to be protected against wear for 100 000 km of mileage;
• the product contains a granulated revitalizant that dissolves completely in oil at operating temperature;

(Not compatible with low-viscosity oils (0W-8; 0W-16; 0W-20; 5W-20))

Pack:

950ml XA 41217