Hydraulic brake pipe (hose) 600mm

Hydraulic brake hose, marked in the name as 600 mm. The sleeve is braided from steel wire, and at both ends there are swivel eyes (banjo) on crimped sleeves.

• The close-up photo of the fitting on this card is the same file as on the products "…1100mm" and "…1400mm" – it is a shared photo for the line, so do not judge the length from it
• How we measure the length: in the photo the arrows rest on the ends of the crimped sleeves, not the edges of the eyes. With the eyes the product is longer, so measure your own old hose the same way – from sleeve to sleeve
• The only product in this category whose diameters can be read is the 1200 mm hose with a black rubber sleeve: it is printed with "Ø7.5mm × Ø3.2mm" – outer 7,5 mm, inner 3,2 mm. Whether the same numbers apply to this product, the maker did not mark
• On the 400 mm hose's photo both fittings are marked with a red callout "D 10" – this is the eye's bore, into which the bolt fits. The maker did not write this number for this product
• Printed on the braided sleeve is "DOT SAE" – this is a marking, not a specific brake fluid class; check your master cylinder cap for which fluid to use
• In this line, two cards are shorter than 600 mm – 500 mm and 400 mm; going up are 640 mm and 800 mm
• Each fitting needs a bolt and two sealing washers – they are in this same category. The bolts differ by thread pitch: M10x1,00 and M10x1,25. For each pitch there is both a plain bolt and the same one with a bleed point. Choose the plain one if your caliper already has its own bleed point
• The hose is replaced not by a wear count, but when it is bulging under lever pressure, when fluid weeps from the sleeve, or when the lever stays soft even after bleeding
• The hose's other end goes to the caliper; the caliper itself is a separate product, listed as "Disc brake cylinder (caliper)"
• After swapping the hose, the system needs to be bled and topped up with fluid – the kind your master cylinder cap specifies; brake fluid is sold separately, in the "Oils & care" category
• This category holds two kinds of products: the hoses themselves and their connecting parts – the tee, bolts and washer. This is not one set, but separate products
• Supplier code WI ZQ4130660 – quote it again when ordering

To be straight with you: the maker marked neither the eye's bore nor the hose's inner diameter for this product. Which specific machine and which years this product is for, the maker did not state, and we do not guess – but we can compare dimensions for you: write us your model and year. Before ordering, straighten your old hose and measure it from sleeve to sleeve, and compare the fittings with the photo – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56