Hydraulic brake pipe (hose) 500mm

Hydraulic brake hose, marked 500 mm in the name. The sleeve is braided from steel wire, with swivel banjo fittings on crimped ferrules at both ends.

• How we measure the length: in the photo the arrows rest against the ends of the crimped ferrules, not against the edges of the banjo fittings. With the fittings included the part is longer, so measure your old hose the same way – ferrule to ferrule
• The only item in this category where the diameters can be read is the 1200 mm hose with a black rubber sleeve: it has "Ø7.5mm × Ø3.2mm" printed on it – 7,5 mm outside, 3,2 mm inside. Whether the same figures apply to this item, the manufacturer didn't mark
• On the photo of the 400 mm hose, both fittings are marked with a red callout "D 10" – that's the banjo bolt hole the bolt goes into. The manufacturer didn't write that figure for this item
• "DOT SAE" is printed on the braided sleeve – that's a marking, not a specific brake fluid class; check your master cylinder cap for which fluid to use
• The list also has 400 mm and 600 mm hoses next to it – in this line the lengths go in hundreds, so the tolerance is measured on the spot, not guessed
• Each fitting needs a bolt and two sealing washers – they're in this same category. The bolts differ by thread pitch: M10x1,00 and M10x1,25. Each pitch comes both plain and with a bleed point. Choose the plain one if your caliper already has its own bleed point
• The hose is replaced not on a wear count, but when it bulges under lever pressure, when fluid seeps past a fitting, or when the lever stays soft even after bleeding
• The other end of the hose goes to the caliper; the caliper itself is a separate item, listed as "Disc brake cylinder (caliper)"
• After swapping the hose the system needs to be bled and topped up with fluid – whichever kind your master cylinder cap specifies; brake fluid is sold separately, under "Oils & care"
• This category holds two kinds of items: the hoses themselves and their connecting parts – tee fitting, bolts and washer. It's not one set, but separate items
• Supplier code WI ZQ413050 – quote it again when ordering

We say it straight. The manufacturer marked neither the banjo bolt hole nor the hose's inner diameter for this item. Which specific machine and which year this item is for, the manufacturer didn't state, and we don't guess it ourselves – but comparing dimensions is something we can do: write us your model and year. Before ordering, straighten out your old hose and measure it ferrule to ferrule, and compare the fittings with the photo – or send a photo: we'll check before you order.

24-month warranty · tel. +370 685 777 56