Hydraulic brake pipe (hose) 2100mm

Hydraulic brake hose, 2100 mm in the name: a sleeve braided from steel wire, with swivelling banjo eyes on crimped ferrules at both ends.

• How we measure the length: in the photo the arrows rest on the ends of the crimped ferrules, not on the edges of the eyes. With the eyes the product is longer, so measure your old hose the same way — from ferrule to ferrule
• The only product in this category on which the diameters can be read is the 1200 mm hose with a black rubber sleeve: there it is printed "Ø7.5mm × Ø3.2mm" — 7.5 mm outside, 3.2 mm inside. Whether the same figures hold for this product, the maker did not mark
• In the photo of the 400 mm hose both end fittings are marked with a red callout "D 10" — that is the hole in the eye the bolt goes into. For this product the maker did not write that figure down
• Printed on the braided sleeve is "DOT SAE" — that is a marking, not a particular class of brake fluid; for which fluid to pour in, look at the cap of your master cylinder
• A red callout in the photo says "210 cm", and the arrows rest on the ends of the ferrules. 210 cm is 2100 mm — it matches the name exactly
• A length like that is needed when the fluid is run right across a quad — from the handlebar to the rear caliper
• Every end fitting needs a bolt and two sealing washers — they are in this same category. The bolts differ in thread pitch: M10x1.00 and M10x1.25. In each pitch there is a plain bolt and the same one with a bleed point. Take the plain one if your caliper has a bleed point of its own
• A hose is changed not by any wear figure, but when it swells as you squeeze the lever, when fluid weeps through a ferrule, or when the lever stays soft even after bleeding
• The other end of the hose goes to the caliper; the caliper itself is a separate product, named "Disc brake cylinder (caliper)" in the same category
• Once the hose has been reconnected, the system has to be bled and topped up with fluid — the one named on the cap of your master cylinder; brake fluid is sold separately, in the "Oils & care" category
• This category holds two kinds of product: the hoses themselves and the parts that join them — a T-piece, bolts and a washer. It is not one kit but separate products
• Supplier code WI ZLK41341 — quote it when you reorder

To be straight with you: the angle of the end fittings and the hole in the eye the maker did not mark. Which machine and which years this product is for, the maker did not state, and we do not guess — but matching dimensions is something we can do: write us your model and year. Before ordering, straighten your old hose out and measure it from ferrule to ferrule, and compare the end fittings with the photo — or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56