Hydraulic brake pipe (hose) 1500mm

Hydraulic brake hose, marked 1500 mm in the name. The sleeve is black rubber, both ends wrapped in a spring guard, and the end fittings are dark, bronze-toned metal eyes.

• The photo shows black plastic clips on the sleeve, used to press the hose against the frame. Whether they slide or are fixed in place, the maker did not mark
• In the same black-sleeve line, the list also has 1200 mm and 640 mm items; the braided-sleeve hoses come in other lengths
• The only item in this category with readable diameters is the 1200 mm hose with a black rubber sleeve: it has “Ø7.5mm × Ø3.2mm” printed on it – outer 7,5 mm, inner 3,2 mm. Whether the same numbers apply to this item, the maker did not mark
• How we measure the length: in the photo the arrows rest on the ends of the crimp ferrules, not on the edges of the eyes. With the eyes the item is longer, so measure your old hose the same way – from ferrule to ferrule
• The photo has no length callout – measure your old hose
• Each end fitting needs a bolt and two sealing washers – they are in this same category. The bolts differ by thread pitch: M10x1,00 and M10x1,25. Each pitch comes both as a plain bolt and as the same bolt with a bleed nipple. Choose the plain one if your caliper already has its own bleed nipple
• The hose is replaced not by a wear number, but when it bulges under lever pressure, when fluid seeps out through the ferrule, or when the lever stays soft even after bleeding
• The other end of the hose goes to the caliper; the caliper itself is a separate item, listed as “Disc brake cylinder (caliper)”
• After fitting the hose, the system needs bleeding of air and topping up with fluid – the type your master cylinder cap specifies; brake fluid is sold separately, in the “Oils & care” category
• This category holds two kinds of items: the hoses themselves and their connecting parts – the three-way fitting, bolts and washer. These are not one kit, but separate items
• Supplier code WI ZQ4139 – quote it again when ordering

To be straight with you: the maker marked neither the diameters nor the eye’s bore for this item. For which specific machine and which year this item is meant, the maker did not state, and we do not guess – but we can compare dimensions: write us your model and year. Before ordering, straighten out your old hose and measure it from ferrule to ferrule, and compare the end fittings with the photo – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56