Hydraulic brake pipe (hose) 1400mm

Hydraulic brake hose, marked 1400 mm in the name. This listing has no photo of its own – both photos are shared with the item "Hydraulic brake pipe (hose) 1100mm", so we describe the look as for the whole line: the sleeve is braided from steel wire, and at the ends are swivel eyes (banjo) on crimped fittings.

• How we measure the length: in the photo the arrows rest against the ends of the crimped fittings, not the edges of the eyes. With the eyes included the item is longer, so measure your own old hose the same way – from fitting to fitting
• The only item in this category with readable diameters is the 1200 mm hose with a black rubber sleeve: it has "Ø7.5mm × Ø3.2mm" printed on it – outer 7,5 mm, inner 3,2 mm. Whether the same numbers apply to this item, the maker did not mark
• In the photo of the 400 mm hose, both fittings are marked with a red callout "D 10" – that is the eye hole the bolt goes through. The maker did not write that number for this item
• Printed on the braided sleeve is "DOT SAE" – that is a marking, not a specific brake fluid grade; to see which fluid to use, check your master cylinder cap
• This listing's photos match byte for byte the item "Hydraulic brake pipe (hose) 1100mm", and on that photo the red callout is marked "110 cm" – that is 1100 mm, not 1400 mm
• So the photo's callout DOES NOT APPLY to this listing. Choose by the 1400 mm stated in the name and measure your own old hose, and disregard the photo's number – we are already asking the maker
• Each fitting needs a bolt and two sealing washers – they are in this same category. The bolts differ by thread pitch: M10x1,00 and M10x1,25. For each pitch there is both a plain bolt and the same one with a bleed point. Choose the plain one if your caliper already has its own bleed point
• The hose is replaced not on a wear count, but when it bulges under lever pressure, when fluid seeps past the fitting, or when the lever stays soft even after bleeding
• The other end of the hose goes to the caliper; the caliper itself is a separate item, listed as "Disc brake cylinder (caliper)"
• After fitting the new hose, the system needs to be bled of air and topped up with fluid – the type your master cylinder cap specifies; brake fluid is sold separately, in the "Oils & care" category
• This category holds two kinds of item: the hoses themselves and their connecting parts – the T-piece, bolts and washer. These are not one kit, but separate items
• Supplier code WI ZQ41393 – quote it again when ordering

To be straight with you: the name says 1400 mm, and the shared photo says 110 cm. Which number is correct, we will not decide ourselves. Which exact machine and year this item is for, the maker did not state, and we do not guess – but comparing dimensions is something we can do: write us your model and year. Before ordering, straighten out your old hose and measure it from fitting to fitting, and compare the fittings with the photo – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56