Mini bike brake levers

Mini bike brake lever with a clamp and wires. This card has no photo of its own – both photos are shared with the product "Mini ATV brake lever LEFT", so we describe what is marked in the photos: 162 mm across the whole assembly, 81.20 mm height and 22.25 mm clamp bore.

• The 162 mm arrow rests on the lever's ball end at one end and on the assembly's farthest edge at the other – this is the whole assembly, not one lever; 81.20 mm was measured from the top of the lever to the bottom edge of the body; 22.25 mm is the clamp bore that the handlebar fits into
• The maker wrote the numbers with a point (81.20 and 22.25), not a comma; we copy them exactly as marked
• The clamp bore is the first number you need to match: a clamp that does not fit the handlebar either will not tighten or will not go on at all
• The photo shows a black wire braid with a white two-contact plug and a green and a black wire – this is the brake light switch
• Both photos on this card match the product "Mini ATV brake lever LEFT" byte for byte, and all three numbers there are the same. Whether this is the same product under two numbers, or two different products, the maker did not explain – we are asking them too
• The other half of the pair is listed as "Mini ATV brake lever RIGHT", and its numbers differ: a 22.50 mm clamp bore, and the length there is marked with two arrows – 130 mm and 36 mm – so do not compare it directly with this card's 162 mm
• It is time to replace it when the lever is bent, when the pivot has come loose, or when the clamp's lug has cracked at the bolt
• Some brake levers in the shop sit not in this category but in the "Levers / Knobs" category – if you do not find a suitable one here, open that one in the catalogue
• This category holds different products: single levers, pairs of them, switch assemblies and master cylinders. This is not one set

To be straight with you: the photos for this card and for "Mini ATV … LEFT" are shared, and all three numbers match. Which exact model and which years this product fits, the maker did not state, and we do not guess – but we can compare dimensions: write us your model and year. Before ordering, photograph your old assembly from above and from the side, so the wires and cable routing show – send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56