Hydraulic brake pipe tee

Hydraulic brake pipe tee – a cast brake fluid distribution fitting. Six dimensions are marked in red in the photos.

• 8.35 mm – the bore of the top spigot; it is smooth, without a thread
• 8.50 mm – the bore of the opposite spigot, and zoomed in the thread turns are clearly visible in it
• 49 mm – the distance between the ends of those two opposite spigots
• 42.50 mm – the total width across; 19 mm – the outer diameter of the threaded spigot; 24 mm – the height of the side spigot
• The photos show FOUR spigots, while the name calls the product a tee. Zoomed in four times, the end of one of them looks flat, with no bore, while the others show a bore – that could explain the name. But we cannot confirm from the photo that this spigot is blind: the maker did not mark it, and we are asking them
• The maker wrote the numbers with a dot (8.35, 8.50, 42.50), not a comma; we copy them exactly as marked
• The surface is unpainted, matte, with a casting seam down the middle – that is visible in both photos
• Each connecting end needs its own bolt and washers – they are in this same category
• The hose is not replaced by a wear figure, but when it bulges under lever pressure, when fluid seeps through the sleeve, or when the lever stays soft even after bleeding the air
• This category holds two kinds of products: the hoses themselves and their connecting parts – the tee, bolts and washer. These are not one kit but separate products

To be straight with you: the maker did not mark the thread pitch – only the bore diameter of 8.50 mm and the spigot outer diameter of 19 mm are marked. Which specific machine and which years this product is for, the maker did not state, and we do not guess – but we can compare dimensions for you: write us your model and year. Before ordering, measure the bores of your old fitting and the distance between the opposite spigots – or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56