Hydraulic brake pipe (hose) 800mm

Hydraulic brake hose, marked 800 mm in the name. The sleeve is braided from steel wire, with swivel eyes (banjo) at both ends, on crimped fittings.

• How we measure the length: in the photo the arrows rest on the ends of the crimped fittings, not on the edges of the eyes. With the eyes the part is longer, so measure your old hose the same way – from fitting to fitting
• The only item in this category with legible diameters is the 1200 mm hose with a black rubber sleeve: it is printed with "Ø7.5mm × Ø3.2mm" – 7,5 mm outer, 3,2 mm inner. Whether the same numbers apply to this item, the maker did not mark
• On the 400 mm hose's photo, both fittings are marked with a red caption "D 10" – that is the bore of the eye into which the bolt fits. The maker did not write this number for this item
• Printed on the braided sleeve is "DOT SAE" – this is a marking, not a specific brake fluid class; check your master cylinder's cap to see which fluid to use
• In the supplier's data for this item was written "hole: 10mm total length: 810mm". The first number matches the caption "D 10" on the related hose, and 810 mm is 10 mm more than the 800 mm in the name – that is exactly what the fittings add
• This is the only card in this line where the supplier's number and the name match this closely
• Each fitting needs a bolt and two sealing washers – they are in this same category. The bolts differ by thread pitch: M10x1,00 and M10x1,25. Each pitch comes both as a plain bolt and as the same bolt with a bleed point. Choose the plain one if your caliper already has its own bleed point
• The hose is replaced not by a wear number, but when it bulges when the lever is squeezed, when fluid seeps through the fitting, or when the lever stays soft even after bleeding the air
• The other end of the hose goes to the caliper; the caliper itself is a separate item, listed as "Disc brake cylinder (caliper)"
• After fitting the hose, the system needs to be bled of air and topped up with fluid – the type your master cylinder cap specifies; brake fluid is sold separately, in the "Oils & care" category
• This category holds two kinds of items: the hoses themselves and their connecting parts – a tee fitting, bolts and a washer. These are not one kit, but separate items
• Supplier codes WI J9014134 · ZQ4135A · ZQ4135B – state them again when ordering

To be straight with you: whether 810 mm was measured with the eyes or without them, the supplier did not write – so we give both numbers. Which specific machine and which years this item fits, the maker did not state, and we do not guess – but we can compare dimensions: write us your model and year. Before ordering, straighten out your old hose and measure it from fitting to fitting, and compare the end fittings with the photo – or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56