Skip to content
CUSTOMER SUPPORT: +370 685 777 56
Right hydraulic brake lever TO-428 - Image 1
Levers / Knobs

Right hydraulic brake lever TO-428

Article no. 62404
5 €
Prices incl. VAT
In stock — Šakiai

Order by 16:00 — Omniva ships today

1
Not sure it fits your bike? Ask our mechanics or see our fitment-by-VIN FAQ
Same-day dispatch — order by 16:00
24-month guarantee
14-day returns
In stock in Šakiai

Product information

Right hydraulic brake lever TO-428: the photo marks a 200 mm length and a D 8 axle bore.

  • The 200 mm arrow runs from the tip of the lever to the edge of the housing – this is the full length of the lever
  • The D 8 arrow rests against the round axle bore in the housing: a bolt passes through it, on which the lever pivots
  • In the photo the lever is light-coloured, aluminium-toned. We measured the photos' brightness: this lever's average brightness is 195 out of 255, while the other five run from 88 to 99. This is the only light one of the six
  • The shop has six right hydraulic brake levers, and they differ almost only in length: 195 mm – one, 200 mm – three, 205 mm – two. The axle bore is the same in all six – D 8. So first measure your old lever, and then, if there are several cards of that length, choose by the features of the lever tip and the axle boss
  • The marking TO-428 in the name is the most precise key to this card: tell us it by phone or in a message, and we will know right away which of the six levers you mean
  • The lever is chosen by three dimensions: the axle bore diameter, the lever length, and the cable or hose connection type. The bore diameter matters most: a wrong bore will not fit over the housing lugs
  • Hydraulic and cable levers look alike from the outside but differ inside: a steel cable hooks onto the cable type, while a master cylinder with a hose screws onto the hydraulic type
  • Brake levers sit in the shop in two places: the subcategory "Levers / Knobs" and the subcategory "Brake levers". If you cannot find the right length here, open the other one too
  • Time to replace when the lever is bent, when the axle bore has widened, or when the lever tip is broken off

To be straight with you: the maker did not state either the master cylinder thread or the clamp bore. The maker did not state which specific model and year this item is for, and we do not guess — but we can compare the measurements: write us your model and year. Before ordering, measure your old lever's length from the axle to the tip and the axle bore diameter — or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56

VIEW ALL