ATV steering rod L160mm

ATV steering rod L160mm: in the diagram, 160 mm is marked across the hex rod between the lock nuts, 230 mm – between both end fittings' pins, and the pin thread is M10. Measure your old rod before ordering.

• The steering rod transfers the handlebar's turn to the wheel: one end connects to the steering column, the other – to the wheel's steering knuckle; a bent rod or worn end fittings throw off the wheel alignment
• We checked where the lines end: 160 mm rests on the rod ends at the lock nuts, 230 mm – on the tops of both pins, 52 mm runs from the bottom of the end fitting body to the top of the pin, and the M10 arrow ends on the pin's thread
• In the name L160mm, in the diagram 160 mm – the numbers match, and both show the length of the rod, not of the whole tie rod
• At both ends – end fittings with black rubber boots and castellated nuts on the pins, near the rod ends – lock nuts; the metal parts have a yellowish zinc plating
• A longer rod of the same design – "ATV steering rod L270mm"
• The photo gives no rod thread size, no thread direction and no model fitment

To be straight with you: which quad the rod fits is not stated in the name, so we do not guess. Before ordering, measure your old rod's distance between the pins and the rod length between the lock nuts, check the pin thread, send us a photo of the old part – we will check it before you order.

24-month warranty · tel. +370 685 777 56