Water pump repair kit version B

Water pump repair kit, version B – an assembled unit made of the impeller, a seal with a spring, and the shaft: the drawing gives 91 mm overall length and 47 mm across the impeller. Compare it with your old unit before ordering.

• The impeller drives coolant through the engine, while the seal with the spring stops it leaking out past the shaft.
• 91 mm is from the tip of the impeller to the end of the shaft; the 47 mm guide lines rest on the edges of the impeller’s base.
• Below the impeller it marks: 28,5 mm across the shiny metal ring, 20 mm across the black rubber ring, 13 mm across the shaft, 9 mm across the lower end of the shaft.
• The lower end of the shaft is milled: a flat face with an arc-shaped edge is visible.
• The name says "kit", but the photo shows a single assembled unit; there are no separate bearings, gaskets or oil seals in it.
• The listing also has a "Water pump repair kit, version C (LONCIN?)" – its unit is different: with a cylindrical body and two sealing rings, 102 mm long.

We write only what we know. Which motorcycle or engine version B is for is not stated in the name, and we do not guess it. Before ordering, measure your old unit’s length, the impeller diameter and the shaft end, and send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56