Cylinder with piston CG200 air 63,50

CG200 cylinder with piston for an air-cooled engine, 63,50. In the box – a cylinder, a piston, a pin, two circlips, a ring set and three gaskets.

• The kit shows: cylinder, piston, gudgeon pin, two pin circlips, a five-piece ring set and three gaskets – one of them with a red outline
• The body has cooling fins and no hose spigot at all – air-cooled, as the name says
• The maker's drawing marks the cylinder bore as 63 mm; sleeve top 69 mm, body height 103 mm, the ribbed section 76 mm, intake port 22,5 mm; from the top 59 mm, 57 mm, 61 mm and 65 mm, and the holes are marked D 9, D 10 and D 12
• The piston is 63 mm diameter and 45,5 mm height, 14,5 mm from the top ring to the pin bore; the pin is 15 mm diameter and 47 mm length
• There is also a CG200 63,50 liquid-cooled cylinder in the listing – there the body is smooth, with a hose spigot, while the piston and pin are the same
• Wear is visible to the naked eye: longitudinal scratches on the cylinder wall, a burnished piston skirt, and a ring that wobbles loosely in its groove – then the whole group is replaced at once
• Supplier codes AT 200QE4050A · 200QE4050C – quote them again when ordering

To be straight with you: the name says 63,50, while the drawing marks the same spot as 63 mm. We are not hiding the difference and we are not picking a side – we are asking the maker. Which specific models and years this cylinder is for, the maker did not state, and we do not guess – write us your machine or send a photo of the old part. Before ordering, remove the spark plug and measure the old cylinder's bore, the pin thickness and the distance between the studs with a caliper – we will check it before you order.

24-month warranty · tel. +370 685 777 56