Cylinder with piston CG150 air 62,00

CG150 cylinder with piston for an air-cooled engine, 62.00. The box holds the whole piston group: cylinder, piston, pin, circlips, rings and three gaskets.

• The set shows: the cylinder, the piston, the gudgeon pin, two circlips for the pin, a five-piece ring set with a copper-coloured oil-ring spring, and three gaskets
• The body has cooling fins and no hose spigot at all — air-cooled, just as the name says
• The maker's drawing marks: top of the sleeve Ø 68 mm, body height 96.5 mm, finned part 69 mm, inlet port 22.5 mm; from above — 59 mm, 57 mm and 61 mm between the stud holes, 65 mm across the sleeve and 61.5 mm across the cylinder bore itself
• Beside each of the top holes the drawing gives its thickness: D 9, D 10 and D 12.5; what the letter means, the maker did not explain, so we take it only as a marking for the hole
• On the drawing the piston is 61.5 mm across and 52.5 mm high, 16.5 mm from the top ring to the pin bore; the pin is 15 mm across and 50 mm long
• The same category also holds a CG150 62.00 with a 13 mm pin — on that drawing the cylinder bore is marked Ø 62 mm and the pin is shorter, 45.5 mm
• Wear can be seen with the naked eye: lengthwise scratches on the cylinder wall, a polished piston skirt, a ring that rocks freely in its groove — then the whole group is replaced at once
• Supplier codes MI 5812 · MO 5906312717696 — quote them when you reorder

To be straight with you: the name says 62.00, while the drawing marks the same place 61.5 mm. We do not hide the difference and we take no sides — we are asking the maker. Which exact models and which years this cylinder is for, the maker did not state, and we do not guess — write us your machine or send a photo of the old part. Before ordering, take out the spark plug and measure the bore of your old cylinder with a caliper, along with the thickness of the pin and the stud spacing — we will check it before you order.

24-month warranty · tel. +370 685 777 56