Gear shifter foot fits DERBI SENDA

Gear shifter foot DERBI SENDA: marked on the drawing as 108 mm, 71 mm and 130 mm, and next to the splined clamp bore – the marks "17frez." and "Ø11/11,5mm". Compare with your old foot before you throw it out.

• The foot fits onto the splines of the gear shift shaft and is clamped by the clamp bolt; a bent or broken foot does not let you shift gears precisely
• We measured the tips of the arrows: 108 mm runs perpendicularly from the top of the tip to the bottom of the clamp, 71 mm – from the top of the tip to the bottom of the hinge, and 130 mm – horizontally from the outer side of the hinge to the outer edge of the clamp
• In the close-up photo, the arrow with the marks points to the splined bore; you cannot count all the splines from the photo – part of the bore near the slot is unclear
• The clamp is split and tightened with a single bolt; the tip is black, ribbed, with a rounded end, fixed by a hinge in which you can see the pivot bolt and the spring
• Fitment to DERBI SENDA is stated in the name, but without a year or version
• The photo gives neither a material marking nor the clamp bolt's size

To be straight with you: what the two numbers in the mark "Ø11/11,5mm" mean is not explained beside it, so we are not picking one of them. Before ordering, count the splines on your shaft and compare them with the mark "17frez.", measure the distance from the shaft to the tip, send us a photo of the old part – we will check it before you order.

24-month warranty · tel. +370 685 777 56