Water pump repair kit version C (LONCIN?)

Water pump repair kit, version C (LONCIN?) – an assembled unit with the impeller, a cylindrical body and two sealing rings: the drawing gives 102 mm length. Compare it with your old unit before ordering.

• The impeller drives coolant through the engine, and the two black rubber rings on the body are for sealing.
• 102 mm is from the tip of the impeller to the end of the shaft.
• The 37 mm guide lines run down to the wide section right below the impeller; 34 mm is marked at the upper sealing ring, 26 mm below the lower one.
• Below that, 25 mm is marked across the lower part of the body, 14 mm across the brass-coloured bush with a rim, and another 14 mm across the end of the shaft.
• After LONCIN in the name there is a question mark: the supplier itself does not confirm the unit is for LONCIN, so we do not confirm it either.
• The name says "kit", but the photo shows a single assembled unit; there are no separate bearings or gaskets in it.
• The listing also has version B – its unit has no cylindrical body with rings, and is 91 mm long.

To be straight with you: neither the motorcycle model nor the engine is in the name, and LONCIN is written with a question mark, so we do not guess the fitment. Before ordering, measure your old unit’s length and the body diameters at the rings, and send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56