Motorcycle stand DL3303H

Motorcycle stand DL3303H – black, raised by a lever: an H-shaped top made of two parallel beams with ribbed mats, a round telescopic post and a lever with a spring by the base. Measure your motorcycle's ground clearance before ordering.

• Both beams are slid under the motorcycle's frame, and pressing the lever down makes the post raise them.
• Two photos show both positions: with the lever down, the post's upper tube is raised and a narrower lower tube shows beneath it; with the lever up, the post is almost fully retracted.
• The beams are joined in the middle; along them are ribbed mats bolted on with small screws, and the ends of the beams are capped with black end caps.
• The lever is a square tube with a round black handle at the end; near the base it is connected with galvanised plates, with a spring beside it.
• The base is H-shaped, and the ends of the legs are capped with black end caps.
• Do not confuse it with "Motorcycle stand DL3303": its photos show a red stand with a rectangular platform and two legs.
• Supplier code DL3303H — give it again when you order.
• The photo has no dimensions and no lifting capacity, and no sticker with any text is visible.

We write only what we know. The supplier did not state the lifting capacity or the lifting height, so we do not invent them. Before ordering, measure the distance from the floor to the underside of your motorcycle's frame and the frame's width at that spot, write us your motorcycle's model and weight — we will check it before you order.

24-month warranty · tel. +370 685 777 56