Motorcycle stand for front wheel mounting to the bridge DL1101C

Motorcycle stand for the front wheel DL1101C, mounted to the bridge: a black tubular frame with four castors, and at the end of the top beam a replaceable zinc-plated pin sticks up. Measure the hole diameter on the underside of your motorcycle's lower bridge before ordering.

• This stand lifts the front of the motorcycle by the bridge: the pin is inserted into the hole on the underside of the lower bridge, so the fork and the front wheel stay free.
• In one photo — four yellow zinc-plated stepped pins with tops of different thickness, and a retaining clip with a wire loop; each pin has a cross-hole in its lower part.
• The inserted pin is held in a black end cap on the beam, with a retaining clip with a ring pushed through its side.
• An engraved mark is visible on the end of one pin, but we cannot read it in the photo.
• In the last photo the stand is placed by the front of a small motorcycle.
• Supplier code DL1101C — quote it again when you order
• The photo gives no pin diameters, no stand height and no lifting capacity.

To be straight with you: the supplier did not provide the pin diameters, so we do not know whether any of the four will fit your motorcycle's bridge, and we will not promise it. Before ordering, measure the hole diameter on the underside of the lower bridge, send us a photo of the front of your motorcycle — we will check it before you order.

24-month warranty · tel. +370 685 777 56