Button with clamp, hermetic

Hermetic button with clamp: the photo marks a Ø 22 mm clamp bore, and at the front a round red rocker switch with the marks O and I in a rubber rim. Measure your handlebar diameter before ordering.

• A switch like this is fitted to the handlebar for an extra circuit – lights, heated grips or another device that has no factory button
• We measured the arrow's ends: the Ø 22 mm arrow crosses the clamp bore from edge to edge, so this is the handlebar bore diameter
• The switch key is red, translucent, with white O and I marks; around it is a rubber sealing rim, so water does not reach the contacts as easily
• The holder is black, cast, with a clamp at the bottom and one tightening bolt
• Three wires with stripped ends come out of the cable: blue, brown and black; they have no terminals
• Three wires mean that one circuit is switched, while the third wire powers the key's backlight, but this is not written on the product itself, so we do not state it as fact
• The photo gives no cable length, no voltage, no current and no protection class
• Supplier code JOV JUNG-16 – state it again when ordering

To be straight with you: which of the three wires is the supply, which is the load and which is the backlight, the maker did not mark, and we do not guess it: connect it the wrong way round and the key lights up but the circuit does not work. Before ordering, measure your handlebar diameter, send us a photo of the old part – we will check it before you order.

24-month warranty · tel. +370 685 777 56