Starter button F1-150 TAIWAN

Starter button F1-150, TAIWAN: the photo marks a Ø 22 mm clamp bore, at the front – 1 black button with the starter symbol, and the cable ends in a black two-contact block. Measure your handlebar diameter before ordering.

• This unit has only one control – the starter button; it has no kill switch, so it is fitted where the kill switch already has a switch of its own
• We measured the arrow ends: the Ø 22 mm arrow crosses the clamp bore from edge to edge, so this is the handlebar bore diameter
• The button is black, rectangular, with an embossed starter symbol; above it on the housing surface there are six round recesses in two rows of three
• The cable is black and short; at its end is a black two-contact block with two square contacts, into which a yellow and a black wire run
• The housing is cast, with a clamp and a bolt; the F1-150 in the name is a model mark, and it is not visible on the product itself in the photo
• The other two photos on this card are shared with four neighbouring button cards, so we do not describe the appearance from them
• The photo gives no cable length, no voltage and no current
• Supplier code TW S17-7019 – quote it again when ordering

To be straight with you: which contact of the block is power and which goes to the starter relay, the maker did not write, and we do not guess. Whether F1-150 means only fitment or also a factory part number is also not explained. Before ordering, measure your handlebar diameter and compare the block, send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56