Button - stop / engine kill ON/OFF

Engine stop button ON/OFF: the frame marks a 25 mm width for the bore with clamp and a 45 mm housing height, and at the front – a red lever switch with a crossed-out engine symbol. Measure your handlebar diameter before ordering.

• This kind of switch cuts the ignition circuit: press it and the engine dies, so it is fitted where the hand can reach it without letting go of the grip
• We measured the ends of the arrows: the 45 mm arrow runs from the top edge of the housing to the bottom, so that is the housing height
• The 25 mm arrow is drawn above the clamp: its right end lines up with the right edge of the handlebar bore, and its left end with the outer edge of the metal clamp. So this is the width of the bore with the clamp; whether it equals the handlebar diameter the drawing does not say, and we do not claim it does
• At the front there is a red lever switch with a crossed-out engine symbol and a loop, and next to it a smaller black switch
• Two wires come out of the black loom: a pink one with a plug-type terminal and a green one with a ring terminal
• The housing is black plastic, clamped to the handlebar by a thin metal band with two screws
• The frame gives neither the loom length, nor the voltage, nor the current

To be straight with you: which of the two wires goes to the ignition and which to earth, the maker did not write, and we do not guess: wired the wrong way round, the engine either does not die, or does not start at all. Before ordering, measure your handlebar diameter, send us a photo of the old part – we will check it before you order.

24-month warranty · tel. +370 685 777 56