Switch assembly ATV left 7 wires 1 socket

Switch assembly for the left side of the ATV handlebar, whose name says 7 wires and 1 socket: on the black housing – two orange buttons, a sliding switch and a lever underneath, and the photo marks a Ø 22 mm handlebar bore. Measure your handlebar diameter before ordering.

• The switch assembly gathers the left-hand controls into one housing, so when one switch fails the whole assembly is usually replaced
• We checked the ends of the lines: the Ø 22 mm helper lines rest on the edges of the handlebar bore on the side of the housing, so this is the handlebar bore's diameter
• At the top – an orange button with a circular-arrow symbol, below it – a sliding switch under two headlight symbols and a dot, and at the bottom – an elongated orange button with a starter symbol (a lightning bolt inside a circular arrow)
• At the bottom a black ribbed lever sticks out to the side; what it is for, we do not determine from the photo
• On the left of the photo, separate from the assembly, two white connector blocks are shown: one has six positions in two rows of three, the other has two contacts
• In the six-position connector block, brass-coloured contacts are clearly visible in four positions, while in the remaining two only colours are visible: red in one, yellow with black in the other – what is fitted in them we cannot make out from the small photo
• The name says 1 socket, while the photo shows two connector blocks; the wires themselves are not visible in the photo, so we cannot check the 7 wires from it. We show both sources and do not choose which is accurate
• The photo gives no loom length, no contact numbering and no fitment to models

To be straight with you: which connector-block contact is for which circuit, the maker did not mark, so we do not guess: wiring it by guesswork would make the switches control the wrong circuits. Which ATV the assembly is for is also not stated in the name. Before ordering, measure your handlebar diameter, count your old assembly's wires and connector-block contacts, and send us a photo of the old part – we will check it before you order.

24-month warranty · tel. +370 685 777 56