Generator windings (stator) ATV110/125 2 pole 5 wire system with gland

Generator windings (stator) ATV110/125 for a quad, 2 poles, 5-wire system with gland.

• The stator is the stationary part of the generator: a magnet spins around it, and the windings generate the current that charges the battery and powers the ignition
• You will recognise a burnt-out stator by blackened windings, a burnt smell, a battery that will not charge and a spark that disappears once the engine warms up
• The photo marks 101 mm and 105 mm – the plate dimensions; place your old stator beside it and compare
• This product differs from the neighbouring 5-wire ATV110/125 stator by the gland – a rubber seal in the centre of the plate. The sensor coil is here too: in the photo it is black, right at the edge of the plate
• Before replacing it, measure the winding resistance and the insulation resistance to earth: often it is not the stator at fault, but the voltage regulator or oxidised connector contacts
• The pole count alone is not enough: the plate diameter, the number of wires and the connector type must all match too – compare against your old stator
• Supplier codes MC WI ZE2002 · 00504 · 2179 – state them again when ordering

To be straight with you: the numbers are taken from the photo's captions, not measured by us. Which year's model and which modification it is meant for, the supplier did not state, and we do not guess – write us your model and year. Before ordering, measure your stator's plate diameter and count the wires – or send us a photo of the old part: we will check.

24-month warranty · tel. +370 685 777 56