Switch assembly with ignition lock, right

Right-side switch assembly with an engine kill switch: the photo shows a black housing with a red rocker kill switch, a lights slider and a red starter button, and the loom ends in 2 white connector blocks. Compare the connector blocks with your own wiring.

• An assembly like this brings the three most-used controls into one place, so if one contact burns out, the whole block gets replaced
• Moulded marks on the housing: a crossed-out engine symbol and an arc next to the red rocker kill switch, and below it three light symbols next to the black slider
• At the bottom, on the front side, sits a red button with a starter symbol – it is pressed with the thumb without letting go of the grip
• The housing has a round handlebar bore and a small hole at the top; the assembly clamps onto the handlebar from two sides
• The loom ends in two white connector blocks; they show greenish, brown and orange wires, but you cannot count them all from this angle
• The photo gives no handlebar bore diameter, no wire length and no numbering of the connector-block contacts
• Supplier code WI AW520152 MI 5462 – quote it again when ordering

To be straight with you: which connector-block contact belongs to which circuit, the maker did not specify, and we do not guess: mix up the starter and lights circuits and the wiring burns. The handlebar bore diameter is also missing from the photo, and we did not measure it ourselves. Before ordering, measure your own handlebar diameter and compare the connector blocks, send us a photo of the old part – we will check it before you order.

24-month warranty · tel. +370 685 777 56