Cylinder with piston PEUGEOT LUDIX 50 40mm TW

PEUGEOT LUDIX 50 cylinder with piston, 40 mm. There is one photo only — the cylinder from above with the piston in it, so we say only what it shows.

• The photo shows the cylinder with the piston inside it; the gudgeon pin, the circlips, the rings and the gaskets are not in it — whether they go into the box, the maker did not state
• Two dimensions are marked in the photo: 47 mm between the top stud holes and 41 mm across the cylinder bore
• The side of the body is not in the photo, so we do not judge the cooling type from a single picture
• The same category also holds a PEUGEOT LUDIX 80 — the stud hole spacing there is the same, 47 mm, but the bore is wider — 47 mm against 41 mm on this one
• Wear can be seen with the naked eye: lengthwise scratches on the cylinder wall, a polished piston skirt, a ring that rocks freely in its groove — then the whole group is replaced at once

To be straight with you: the name says 40 mm, while the bore in the photo is measured at 41 mm. We take no sides and are asking the maker; meanwhile, measure the bore of your own cylinder. Which exact models and which years this cylinder is for, the maker did not state, and we do not guess — write us your machine or send a photo of the old part. Before ordering, take out the spark plug and measure the bore of your old cylinder with a caliper, along with the thickness of the pin and the stud spacing — we will check it before you order.

24-month warranty · tel. +370 685 777 56