Cylinder with piston CG200 water 63,50

CG200 cylinder with piston for a water-cooled engine, 63,50. In the box – a cylinder with a sealing ring, a piston, a pin, circlips, rings and three gaskets.

• The kit shows: a cylinder with a black sealing ring fitted, a piston, a gudgeon pin, two pin circlips, a five-piece ring set and three gaskets
• The body is smooth, with no cooling fins, with a spigot for the coolant hose and a rubber sealing ring – it is liquid-cooled
• The maker's drawing marks the cylinder bore as 63 mm; the top face 94 × 94 mm, 82 mm between the stud holes, 80,5 mm and 8 mm at the sleeve; the holes are marked D 7, D 9, D 10 and D 12
• From the side: sleeve 73 mm, body height 107,5 mm, the ribbed section 76 mm, hose spigot D 14, intake port 22,5 mm and 64 mm
• The piston is 63 mm diameter and 45,5 mm height, 15 mm from the top ring to the pin bore; the pin is 15 mm diameter and 47 mm length
• There is also another CG200 63,50 water-cooled cylinder in the listing, whose drawing marks the bore as 63,5 mm, and an air-cooled version with fins
• Wear is visible to the naked eye: longitudinal scratches on the cylinder wall, a burnished piston skirt, and a ring that wobbles loosely in its groove – then the whole group is replaced at once
• Supplier code MI 0690 – quote it again when ordering

To be straight with you: the name says 63,50, while the drawing marks the same spot as 63 mm. We are not hiding the difference and we are not picking a side – we are asking the maker. Which specific models and years this cylinder is for, the maker did not state, and we do not guess – write us your machine or send a photo of the old part. Before ordering, remove the spark plug and measure the old cylinder's bore, the pin thickness and the distance between the studs with a caliper – we will check it before you order.

24-month warranty · tel. +370 685 777 56