Motorcycle stand for rear wheel DL1101B+U

Motorcycle stand for rear wheel DL1101B+U with yellowish zinc-plated U-shaped forks on both posts; the stand itself is red tubular, with four casters and a long handle. Before ordering, check whether your motorcycle's swingarm has pins fitted for a stand.

• The U-shaped forks fit around the pins screwed into the swingarm; pressing the handle down raises the rear of the motorcycle and the rear wheel stays off the ground.
• Each fork is a plate with a deep U-shaped notch at the top and three holes at the bottom: two smaller ones and one larger one.
• The fork is connected to a zinc-plated rod inserted into a red square sleeve at the top of the post, and a black knob clamps the rod.
• Under each post — two black casters, and at the tube joints you can see sleeves with small screws.
• If your swingarm has no such pins, the U-shaped forks will have nothing to hook onto; the list also has "Motorcycle stand DL1101B+L" with L-shaped supports.
• The photo has no dimensions, no lifting capacity, and no distance between the forks.

We write only what we know. What diameter of pins the forks are meant for, and whether the distance between them can be adjusted, the supplier did not state. Before ordering, measure your swingarm's pin diameter and the distance between them, send us a photo of the rear of your motorcycle — we will check it before you order.

24-month warranty · tel. +370 685 777 56