DELTA rear sprocket 420 32z

DELTA rear sprocket 420, 32 teeth: four mounting holes and four elongated lightening holes, in the drawing 134 mm across the teeth and a 54 mm central hole. Measure your old sprocket before ordering.

• The 420 marking must match your chain's and front sprocket's marking, otherwise the teeth will not match the chain pitch.
• We measured the line ends: 134 mm rests on the tooth tips on the left and right, 54 mm on the edges of the central hole.
• Between the holes, the drawing gives two numbers — 49,50 mm at the top, 70 mm at the bottom — but both are drawn between the same left and right holes, so we cannot tell from the drawing which of them is the real distance between the centres.
• In the photo we counted 32 teeth — the same as in the name; no stamped marking is visible on the sprocket.
• The photo gives no hole diameter and no sprocket thickness.

We write only what we know. Which machine this sprocket is meant for is not stated in the name, and we do not guess it. Before ordering, count your old sprocket's teeth, measure the central hole and the distances between the centres of adjacent and diagonal holes, send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56