Verylube Radiator Flush - cooling system flush

While the cooling system operates, deposits form in it that reduce its efficiency. For effective engine cooling, it is recommended to flush the system every time the coolant is changed.

• Quickly (within 10 min) dissolves deposits, dirt and rust that have accumulated in the radiator and the cooling system.
• Neutralises acids that have formed in the system and protects against corrosion.
• Creates a protective anti-corrosion film on the parts of the cooling system.
• Improves cooling efficiency.
• Completely safe to use.
• Neutral to all materials of the cooling system.

Composition

Surfactants, neutral acids, corrosion inhibitors, additives in water.

Instructions for use

Warm the engine up to operating temperature. After switching the engine off, pour the product into the radiator tank. Start the engine and leave it idling for 10 minutes with the cabin heating on. Switch the engine off. Drain the used coolant. Fill the cooling system with water and, after starting the engine, leave it idling for 2–3 minutes. Switch the engine off, drain the water from the cooling system and pour in new coolant.

ATTENTION!

When the engine is hot, the antifreeze in the cooling system is under pressure. Be careful when unscrewing the radiator cap: hot steam or liquid may burst out from under it.

Dosage

250 ml of the product is intended for a cooling system with a capacity of 10–12 L.

Pack

250 ml XB 30032