Pair of steering rod ends ATV conical surface

A pair of ATV steering rod ends with a conical surface: the photo marks 69 mm and 77 mm, an M10 thread and a 30 mm diameter of the body with the cap, and the third photo adds a further 80 mm, 56 mm and 34 mm.

• In the third photo the maker, for the only time in this whole line, wrote the thread direction: next to one end "M10 lewy gwint", next to the other "M10 prawy gwint". So in the pair one thread is left-hand, the other right-hand
• The labels in that photo are in Polish, not Lithuanian – we quote them exactly as the maker wrote them
• The numbers in that same photo: 80 mm total length, 56 mm height, 34 mm the threaded part of the shank; on one side a further 11 mm, on the other 26 mm
• Both "lewy/prawy" arrows point to the horizontal shanks, while the separate M10 marks below point to the vertical pins: both the shank and the pin are M10 here
• In the first photo the same pair is marked differently: 77 mm, 69 mm, 30 mm and M10. The two photos measure different things, so the numbers do not match
• The name mentions a conical surface: in the photo the pin's neck is indeed conical, not cylindrical
• The end is chosen by two things: the thread size at the rod's end and the pin's thread, by which it is fastened to the arm. If even one does not match, the part stays on the shelf
• On steering rods, one end usually has a left-hand thread, the other a right-hand one: this lets the rod's length be adjusted without turning the ends themselves. When the rod is turned, both ends move at the same time
• The shop has four pairs of steering rod ends, and they sit in two places: two in the "Chassis & suspension" section and two in the "Tie rods" subcategory. A related ball-joint set sits in a third place – the "Joints" subcategory
• It is time to replace it when you can feel play in the end by moving it by hand, when the rubber cap is torn, or when the handlebar moves freely before the wheels turn
• Supplier code WI ZQ5131 – state it again when ordering

To be straight with you: which end goes to the left side and which to the right, the maker did not mark – only the thread direction is marked. Which specific model and which years this part fits, the maker did not state, and we do not guess – but comparing the dimensions is something we can do: write us your model and year. Before ordering, measure the thread diameter of your old rod and the pin's thread – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56