Cross motorcycle handlebar bridge (fork) DB110

Cross motorcycle handlebar bridge DB110: the photo marks the handlebar holder bolt pitch of 66 mm, and the diameters differ on each plate.

• Each photo shows one plate with its own pair of diameters: the second photo — Ø 24,5 mm central bore and Ø 32,55 mm fork-leg clamp, the third — Ø 21,5 mm and Ø 32,2 mm. The plates can be told apart without the labels too: one has four small Ø 7,9 mm holes, the other has none
• So we do not claim one pair of diameters as the only one — we show both, exactly as they are marked by their own plate
• The Ø 7,9 mm arrow points to the small holes, while 66 mm and 25 mm measure the gap between them: 66 mm — between the two upper ones, 25 mm — between the upper and the lower one. That is the handlebar holder bolt pitch
• The photo shows that the set has two plates: the upper one smooth, the lower one with casting ribs and wider clamps
• The bridge is chosen to match the fork-leg diameter and the gap between the legs: if even one of them does not match, the legs will not fit
• Time to replace it when a clamp lug is snapped off, when the plate is bent after a fall, or when the bolt thread in the plate is stripped

To be straight with you: the photo does not mark the distance between the fork-leg centres, and that is exactly what decides whether the bridge fits. The maker did not state which specific model and year this part is for, and we do not guess — but we can compare the dimensions for you: write us your model and year. Before ordering, measure your fork-leg diameter and the distance between their centres — or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56