Quad rear axle QW ATV 02C

Quad rear axle QW ATV 02C: the photo marks 740 mm overall length and a second, smaller dimension at the splined end.

• The second callout in the photo reads "27mm". We measured it on the photo itself, scaling against its own 740 mm line: the bracket spans about 27 mm of the axle
• The neighbouring listing's photo has the same bracket marked "2,7mm". The maker's two labels differ by a factor of ten, while the geometry is the same in both photos, so we do not state this number as fact
• The photo shows a gold-zinc-plated axle with two knurled splined sections in the middle and splined ends
• Both axles in this row share the same overall length – 740 mm – so you cannot choose between them by length. What exactly sets them apart, the maker did not write, and the photos do not show it
• An axle is matched by two dimensions: the shank diameter and the length. The diameter must match the wheel bearing's inner race, and the length must be enough to pass through both fork ears with the nut
• The third dimension is the threaded end: if it is too short the nut will not bite, if too long it bottoms out before it clamps
• The wheel bearings are often replaced together with the axle: the shop has a separate subcategory "Bearings" in the same section
• Time to replace it is when the axle is bent, the thread is stripped, or the shank is worn through at the bearing seat

To be straight with you: the maker marked the shank diameter neither in the name nor in the photo. Which exact model and year this axle fits, the maker did not state, and we do not guess – but we can compare dimensions for you: write us your model and year. Before ordering, measure your old axle's shank diameter and overall length – or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56