DELTA front wheel axle D10 180mm

DELTA front wheel axle: the name states D10 and 180 mm, while a grey callout in the photo marks Ø 10 mm and 195 mm.

• We measured where the 195 mm line ends: its ends match the part's outline to within 0,2 mm. That means the 195 mm is the full length from the hex head to the edge of the screwed-on nut
• The 180 mm given in the name does not match any line in the photo. We measured the nut with washer in the photo — it takes up about 14 mm; 195 mm without it would give about 181 mm, which is close to the name's figure. But what the maker actually measured, he did not write, so we show both numbers
• The Ø 10 mm arrow points to the smooth shaft between the head and the thread
• The photo shows a hex nut with a washer already screwed onto the threaded end, and a second washer at the head. Whether the nut and washers are included in the price, the maker did not mark
• The axle is chosen by two dimensions: shaft diameter and length. The diameter must match the wheel bearing's inner ring, and the length must be enough to pass through both fork lugs with the nut on
• The third dimension is the threaded end: if it is too short, the nut will not bite, and if it is too long, it hits something before it tightens
• Wheel bearings are often replaced together with the axle: the shop has a separate "Bearings" subcategory in the same section
• Time to replace it when the axle is bent, when the thread is stripped, or when the shaft is worn through where the bearing sits

To be straight with you: the thread length and pitch are not marked in the photo. The maker did not specify which exact model and year this axle is for, and we do not guess — but we can compare the measurements for you: write us your model and year. Before ordering, measure your old axle's shaft diameter and overall length — or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56