ATV fork joint, press-fit, h8mm

ATV press-fit fork ball joint, marked in the name as h8mm. The photo marks a 79 mm overall height, 36 mm and 20 mm sections, an M12x1.25 thread and a Ø 32 mm body.

• Honestly: the number 8 does not appear even once in the photo. What "h8" in the name means, the maker did not explain, so we do not state this size as fact
• Of the two cards, this is the only one that gives the thread pitch: M12x1.25, not just M12
• 79 mm – full height, 36 mm – the stepped pin, 20 mm – the threaded section. The Ø 32 mm arrow rests on the body's rim
• The photo shows a corrugated rubber boot and a brass ring under it – the boot protects the ball from dirt
• There are three press-fit cards of this line in the shop: h22mm, h12mm and h8mm. The first, h22mm, has in its photo: 81 mm and the same D 32 body, and its photo also has three small extra parts lying in it; h12mm has a 75 mm overall length in the supplier data
• A ball joint is chosen by three sizes: the body diameter, the pin thread and the overall height. If even one does not match, the part either will not press in or will not tighten
• It is time to replace it when you can feel play in the joint by hand, when the rubber boot is torn, or when the arm is bent after a fall

To be straight with you: both cards of this line share the same code in the maker's catalogue, so they cannot be told apart by code. Which specific model and which years this part fits, the maker did not state, and we do not guess – but we can compare the dimensions for you: write us your model and year. Before ordering, measure your old part's body diameter and overall height – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56