ATV fork joint, press-fit, h22mm

ATV press-fit fork joint, marked in the name as h22mm. In the photo: 81 mm overall height, 20 mm housing section, M12 pin and D 32 housing.

• Honestly: the number 22 does not appear in the photo, not even once. What “h22” means in the name, the maker did not explain, so we do not state this size as fact.
• The 81 mm arrow runs from the bottom of the housing to the end of the pin — that is the overall height. The 20 mm arrow measures the cylindrical section of the housing that presses into the arm.
• The D 32 arrow points to the side of the housing: it is exactly this diameter that must match the bore in the arm.
• Next to the joint in the photo lie three more parts: a castellated nut, a spring circlip and a wire ring. How many of these you get when ordering, the maker did not mark.
• The shop carries three press-fit cards in this line: h22mm, h12mm and h8mm. The second, h8mm, is marked in the photo at 79 mm, while the third, h12mm, has 75 mm overall length and a 32 mm insertion diameter in the supplier's data.
• A ball joint is chosen by three sizes: the housing diameter, the pin thread and the overall height. If even one does not match, the part will either not press in or will not tighten.
• Time to replace it: when moving the joint by hand you feel play, when the rubber boot is torn, or when the arm is bent after a fall.

To be straight with you: both cards in this line carry the same code in the maker's catalogue, so they cannot be told apart by code. Which specific model and which years this part is meant for, the maker did not specify, and we do not guess — but comparing dimensions is something we can do: write us your model and year. Before ordering, measure the housing diameter and overall height of your old part — or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56