Handlebar grips XL-278C-1 (pair)

Handlebar grips XL-278C-1 (pair): the photo marks a 121 mm length and two diameters – 22 mm and 25 mm.

• The 121 mm arrow runs along the grip, 22 mm sits against the narrower end, 25 mm against the wider one. So the grip is tapered, not the same thickness throughout
• The photo shows black rubber with a white marbled pattern and a thickened tip. One end is closed
• The cards in this row mark these lengths: 121 mm, 155 mm and 160 mm in one pair and 165 mm in another. Choose this one, 121 mm, when there is little space between the clamp and the end of the handlebar
• The grip is chosen by the handlebar tube diameter: too narrow and it will not go on, too wide and it will spin. The left side fits straight onto the tube, the right onto the throttle sleeve, so their bores differ
• The second dimension is length: it must fit between the clamp and the end of the handlebar. In a pair, the throttle-side grip is usually shorter, because the housing takes up part of the space
• Time to replace when the rubber has hardened and slips in wet weather, when the pattern is worn smooth, or when the grip spins on the handlebar

To be straight with you: whether both grips in the pair are the same length is not marked on the photo. The maker did not state which specific model and year this pair is for, and we do not guess — but we can compare the measurements: write us your model and year. Before ordering, measure your handlebar diameter and the free space between the clamp and the end — or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56