Left handle with clamp

Left handle with clamp: the photo marks a 175 mm length and a 76 mm clamp height.

• The 175 mm arrow runs horizontally across the whole assembly – from the cable adjuster nut on the left to the tip of the lever, while 76 mm runs vertically, from the top of the housing to the bottom of the clamp
• The photo shows that this is the whole assembly: lever, housing, clamp and cable adjuster with a knurled nut
• The clamp fits onto the handlebar, so one more dimension has to match – the handlebar tube diameter at the clamp point
• The lever is chosen by three dimensions: the axle bore diameter, the lever length, and the cable or hose connection type. The bore diameter matters most: a wrong bore will not fit over the housing lugs
• Hydraulic and cable levers look alike from the outside but differ inside: a steel cable hooks onto the cable type, while a master cylinder with a hose screws onto the hydraulic type
• Brake levers sit in the shop in two places: the subcategory "Levers / Knobs" and the subcategory "Brake levers". If you cannot find the right length here, open the other one too
• Time to replace when the lever is bent, when the axle bore has widened, or when the lever tip is broken off

To be straight with you: the maker did not mark the clamp bore diameter, and that is exactly what decides whether the assembly will fit your handlebar. The maker did not state which specific model and year this item is for, and we do not guess — but we can compare the measurements: write us your model and year. Before ordering, measure your handlebar diameter at the clamp point — or send a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56