Throttle grip set A80 A50 for bicycle engine

Throttle grip set A80 A50 for a bicycle engine: the photo shows the whole assembly, no dimensions marked.

• Honestly: on this card's photo the maker did not write a single number, so we cannot give the handlebar bore size
• The photo shows four parts: a black rubber grip with a white plastic sleeve, a separate second grip, a body with a yellow lever, and two wires
• The white sleeve in the set is the same part sold separately: its own card's photo marks: 135 mm and D 23
• The yellow lever on the body is a choke or kill-switch control; what exactly it controls, the maker did not write
• The first size you need to match is the handlebar tube diameter at the clamp: too wide a bar will not fit into the body, too narrow will let the body twist
• The second thing is the cable end: throttle cables end in cylindrical nipples of different sizes, and the wrong nipple will not seat in the drum
• The throttle grip must return by itself when you let go. If it stays turned without pressure, the cause is either a dirty drum or an over-tightened clamp
• It is time to replace it when the body is cracked at the screw, when the drum is worn, or when the grip no longer returns by itself

To be straight with you: the maker gave neither the grip length nor the handlebar bore. Which specific model and which years this product fits, the maker did not state, and we do not guess – but we can compare the dimensions for you: write us your model and year. Before ordering, measure your handlebar diameter at the clamp and photograph the old cable nipple – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56