Gas handle plastic nozzle

Throttle grip plastic nozzle: the photo marks: 135 mm length and D 23 diameter.

• The 135 mm arrow runs the length of the whole nozzle, D 23 refers to its end with the collar
• The nozzle is a white plastic tube that fits onto the handlebar and on which the rubber grip itself rotates. It is exactly what determines whether the grip turns smoothly
• Honestly: the second photo on this card is not a photo of the item itself. We compared the photos point by point – it matches, without any difference, the photo of another product in this catalogue, the throttle grip set. So we do not describe the whole set as if it were this item: only the nozzle is sold here
• The nozzle's inner bore is not marked in the photo, and it is exactly that which fits onto the handlebar
• The first dimension that has to match is the handlebar tube's diameter at the clamp point: too wide a handlebar will not fit into the body, too narrow will let the body turn on it
• The throttle grip must spring back by itself once you let go. If it stays turned when not pressed, either the drum is dirty or the clamp is over-tightened
• It is time to replace it when the body is cracked at the bolt, when the drum is worn, or when the grip no longer springs back by itself

To be straight with you: the maker did not mark the inner bore or the collar's thickness. Which specific model and which years this item fits, the maker did not state, and we do not guess – but comparing the dimensions is something we can do: write us your model and year. Before ordering, measure your handlebar's diameter at the clamp point and photograph the old cable end – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56