Disc brake cylinder (caliper) H

Disc brake caliper, marked in the name with the letter H. The mounting holes in the photo are marked M8, and the distance between them is 43 mm; on the neighbouring products in this line the same spacing is 57 mm, 66,5 mm, 68 mm and 95 mm.

• The other photo marks 19 mm and 13 mm
• What each dimension measures, the maker did not write, so we do not assign them a meaning – we compare number with number
• The whole item is black; the housing has cast-in markings, but in the photo they are too small and we do not transcribe them
• The same line in the list: "Disc brake cylinder (caliper) QT-4" – M8 holes 45 mm and 58 mm apart
• The caliper is replaced not because of wear, but when the piston sticks, fluid weeps past the seal, or the pad retaining pin has snapped; the pads themselves are a separate replaceable part
• Do not confuse it with the master cylinder: the caliper presses the pads against the disc, while fluid is fed to it by a separate item – the same category has "Foot brake master cylinder RZ-D002" and four more of its relatives
• Supplier code WI ZLK4101 – quote it again when ordering

To be straight with you: the maker did not state the piston diameter or the hose thread. Which specific model and which years it is for, the maker did not write, and we do not guess – write us your model and year. Before ordering, measure the spacing of your caliper's mounting holes, their thread and the disc thickness – or send us a photo: we will check it before you order.

24-month warranty · tel. +370 685 777 56