Engine studs 95/188 M6 ATV JH70

ATV JH70 engine studs M6 (95/188 in the name): the photo shows four yellowish studs, two shorter and two longer, and the diagram marks the outer ones as 295 mm and 200 mm. Measure your old studs before ordering.

• These studs clamp the cylinder and head to the crankcase: the lower ends are screwed into the crankcase, and nuts are screwed onto the upper ends.
• The diagram's lines are drawn along the full length of the outer studs: the left one – 295 mm, the right one – 200 mm; the "M 6" arrows end on the upper threads of the two middle studs, "D 5,2" – on their smooth sections.
• But in the photo, the stud labelled 295 mm is not longer but slightly shorter than the stud labelled 200 mm, so at least one number on the diagram is wrong.
• The name gives 95 and 188, the diagram gives 295 and 200 mm; the sources do not match, and we do not pick either one.
• The photo does not show any nuts, and the name does not state the number of studs.

To be straight with you: we cannot rely on either the name's or the diagram's numbers here, so we do not guess the true length; JH70 is given without the ATV model, so we do not promise fitment either. Before ordering, measure your old studs' length end to end and their thread, send us a photo of the old part — we will check it before you order.

24-month warranty · tel. +370 685 777 56